Edirol F-1 Manuale Utente Scaricare il pdf (Pagina 6)

Using F-1 Net Control

First, check the network settings shown on the screen of the F-1. Use the “Network Setting” menu to check the settings for “Check Host Name,”

“IP Address,” and “Port Number.” We recommend that you note down these values so that you can make the same settings in the program.

fig.f1-unit-setup.eps

Enter the host name or IP address for the F-1.

Enter the host name or the IP address for the F-1 at the location shown in the figure below.

fig.host-name-input.eps

Display the port number setting window.

Click the button shown below to display the setting window for the port number.

fig.port-setup-open.eps

Set the port number.

At the window shown below, choose the port number. Set the port number that the program uses to match the port number of the F-1.

fig.port-setup-screen.eps

Making the Settings to Match the Connected F-1

* The port number of the F-1 is set to 50000 by default. If the number on the unit hasn’t been changed from this, you can use the same setting

unchanged.

* However, if the port number has been changed because of the requirements of the network, the port number set by this program must be changed to

match it.

* When you’re using a connected F-1 in a network environment, such as on a company LAN, an available port number must be assigned. Check with

the network administrator to determine what port numbers are available for use.

1 2 3 4 5 6 7 8 9 10

Nessun commento

Edirol F-1 Manuale Utente Pagina 6